1RM.fit1RM.fit
Get Started Free
Exercise Library

Band Skull Crusher

Band Skull Crusher is a beginner band exercise for the primary: triceps brachii secondary: anconeus, with the shoulders (anterior deltoids) assisting. Most lifters train it for 2 to 3 sets of 12 to 20 reps.

This exercise is performed using a resistance band anchored behind the body while extending the arms overhead. The elbows are bent to lower the hands toward the forehead, then the arms are straightened to return to the starting position, keeping the upper arms stable throughout.

TricepsBand
Band Skull Crusher
Primary muscle
Primary: Triceps Brachii Secondary: Anconeus
Secondary muscles
Shoulders (Anterior Deltoids)
Equipment
Band
Difficulty
Beginner
Typical volume
2–3 sets × 12–20 reps
Category
Triceps

How to Do the Band Skull Crusher

  1. Anchor a resistance band low to a sturdy post or rack upright and lie on your back with your head toward the anchor.
  2. Grip the band ends or handles and raise your arms so your upper arms point straight up or angle slightly back.
  3. Shuffle away from the anchor until the band has light tension with your elbows bent and hands near your forehead.
  4. Keep your upper arms still and extend your elbows until your arms are straight above your chest.
  5. Squeeze the triceps hard at lockout for one second, where band tension is highest.
  6. Bend your elbows slowly to return your hands toward your forehead without letting your upper arms drift.
  7. Repeat for the set, keeping your lower back flat and shoulders relaxed on the floor or bench.

Common Mistakes

  • Upper arms drifting: Letting the elbows swing forward turns the movement into a pullover and reduces triceps work. Lock the upper arms in place and move only at the elbows.
  • Elbows flaring out: Wide elbows shift strain to the shoulders and inner elbow. Keep the elbows pointing toward the ceiling, roughly shoulder width apart.
  • Too little band tension: Lying too close to the anchor leaves the band slack at the bottom. Move further away so there is tension through the full range.

Programming Tips

Place the band skull crusher at the end of an upper body or arm session as a triceps finisher, using 2 to 3 sets of 12 to 20 reps. It is ideal for home training, warm-ups before heavy pressing, and adding triceps volume with little elbow stress.

Anchor the band low behind your head and keep your upper arms angled slightly back toward the anchor. Start with a light or medium band that allows 20 smooth reps, then progress by moving further from the anchor, doubling the band or choosing a heavier band once you exceed 20 reps. The most common fault is the upper arms swinging forward; fix it by imagining your elbows are pinned to a wall behind you.

Common Questions

Do band skull crushers build triceps?

Yes, they effectively train all three triceps heads, especially when taken close to failure. Bands give the most resistance at lockout, which complements free weight extensions.

Are band skull crushers easier on the elbows?

Usually, yes. The resistance is lighter in the stretched position where elbows tend to hurt with an EZ bar, so many people with elbow pain tolerate bands better.

Can I do skull crushers with a band without an anchor?

You can pin the band under your upper back or a bench leg, but a low anchor behind your head gives smoother tension. Any sturdy fixed object at floor level works.

Related triceps exercises

Other ways to train the same muscle, with whatever equipment you have.

Exercise Ball Dip
Ball
Weighted Bench Dip
Others
Weighted Tricep Dips
Weighted
Cable Kickback
Cable
Dumbbell Lying One Arm Supinated Triceps Extension
Dumbbell
Triceps Stretch
Bodyweight

See every triceps exercise →

Programming the Band Skull Crusher

Track This Exercise in the App

Log your band skull crusher sets in 1RM.fit and watch your estimated 1RM update automatically as you get stronger.

Download on theApp StoreGET IT ONGoogle Play