1RM.fit1RM.fit
Get Started Free
Exercise Library

Cable Kickback

Cable Kickback is a beginner cable exercise for the primary: triceps secondary: anconeus. Most lifters train it for 2 to 3 sets of 12 to 20 reps.

The cable kickback isolates the triceps by extending the arm behind the body against constant cable tension. Hinge forward slightly, keep the upper arm fixed, and extend the elbow fully before returning under control.

TricepsCable
Cable Kickback
Primary muscle
Primary: Triceps Secondary: Anconeus
Equipment
Cable
Difficulty
Beginner
Typical volume
2–3 sets × 12–20 reps
Category
Triceps

How to Do the Cable Kickback

  1. Set a single handle on a low pulley and grasp it with one hand, palm facing inward.
  2. Step back, hinge at the hips until the torso is near parallel and brace the free hand on the thigh or a bench.
  3. Raise the working upper arm until it is parallel to the floor with the elbow bent at 90 degrees.
  4. Extend the elbow, driving the hand straight back until the arm is fully locked out.
  5. Squeeze the triceps hard at the top for one second with the upper arm still.
  6. Bend the elbow slowly back to 90 degrees without dropping the upper arm.
  7. Complete all reps on one arm, then turn around, switch hands and repeat on the other side.

Common Mistakes

  • Upper arm dropping: Letting the elbow sink below the torso shortens the range and removes tension at lockout. Keep the upper arm parallel to the floor through the set.
  • Swinging the weight: Using the shoulder and torso to throw the handle back turns the move into a rear delt swing. Lower the load and move only the forearm.
  • Standing too upright: A tall torso puts the lockout against gravity poorly and limits range. Hinge until the back is nearly flat.

Programming Tips

Perform 2 to 3 sets of 12 to 20 reps per arm as a finishing movement at the end of a push or arm session. It drives blood into the triceps and trains the fully shortened position that pushdowns and extensions partly miss, which helps with lockout strength and arm definition. It is not a strength builder, so loads stay light and reps high.

Set the pulley at its lowest position, hinge the torso flat and brace the free hand so the body is still. Start with 5 to 7.5 kg and add 2.5 kg once 20 clean reps per arm are easy; most lifters top out around 15 kg. The most common fault is the upper arm dropping as the set goes on; fix it by pausing at lockout and ending the set when the elbow can no longer stay high.

Common Questions

What does the cable kickback work?

It works all three heads of the triceps with a strong peak contraction at lockout, particularly the lateral head. The rear delt holds the upper arm up isometrically.

How much weight should I use for cable kickbacks?

Start with 5 to 7.5 kg and stay in the 7.5 to 15 kg range even when advanced. Strict form at full lockout matters far more than the number on the stack.

Cable kickback or dumbbell kickback, which is better?

The cable version is better because tension stays on the triceps through the entire arc, while a dumbbell only loads the last part of the rep. Dumbbells are fine when no cable is available.

Do kickbacks build triceps size?

They contribute, especially for the lockout and lateral head, but they cannot be loaded heavily enough to be a primary mass builder. Use them to finish a session after pushdowns, dips or extensions.

Related triceps exercises

Other ways to train the same muscle, with whatever equipment you have.

Cable Overhead Triceps Extension (Rope Attachment)
Cable
Cable Pushdown
Cable
Cable Pushdown (With Rope Attachment)
Cable
Barbell Jm Bench Press
Barbell
EZ Bar Seated Triceps Extension
EZ Bar
Assisted Standing Triceps Dip
Assisted

See every triceps exercise →

Programming the Cable Kickback

Track This Exercise in the App

Log your cable kickback sets in 1RM.fit and watch your estimated 1RM update automatically as you get stronger.

Download on theApp StoreGET IT ONGoogle Play