1RM.fit1RM.fit
Get Started Free
Exercise Library

Dumbbell Biceps Curl (With Arm Blaster)

Dumbbell Biceps Curl (with Arm Blaster) is an intermediate dumbbell exercise for the biceps brachii, with the brachialis and brachioradialis assisting. Most lifters train it for 3 to 4 sets of 8 to 12 reps.

Biceps Brachii, Brachialis, Brachioradialis, Forearms

BicepsDumbbell
Dumbbell Biceps Curl (with Arm Blaster)
Primary muscle
Biceps Brachii
Secondary muscles
Brachialis, Brachioradialis, Forearms
Equipment
Dumbbell
Difficulty
Intermediate
Typical volume
3–4 sets × 8–12 reps
Category
Biceps

How to Do the Dumbbell Biceps Curl (with Arm Blaster)

  1. Hang the arm blaster around the neck and adjust the strap so the plate sits across the upper abdomen.
  2. Hold a dumbbell in each hand with palms facing forward and press the backs of the upper arms into the plate.
  3. Stand tall with the feet hip width, knees soft and the core braced.
  4. Curl both dumbbells up by bending the elbows, keeping the upper arms pinned to the plate.
  5. Squeeze the biceps hard at the top with the wrists straight.
  6. Lower under control over two to three seconds until the arms are fully straight, then repeat.

Common Mistakes

  • Elbows lifting off the plate: The upper arms push forward at the top to shorten the lever. Keep the triceps pressed into the plate from start to finish.
  • Leaning back to finish: The torso tips back when the weight is too heavy. Brace the core and reduce the load so the body stays still.
  • Stopping short of straight: Half reps at the bottom skip the stretched position. Let the elbows extend fully on each rep.

Programming Tips

Use the arm blaster dumbbell curl as the strict biceps exercise in an arm or pull session, for 3 to 4 sets of 8 to 12 reps. It is an isolation movement, so place it after rows or chin ups and before lighter forearm work.

Set the plate so it covers the upper arm just above the elbow, not the elbow itself. Start with 6 to 10 kg per hand, roughly 20 percent less than a free standing curl, and add 1 to 2 kg when all sets reach 12 clean reps. The most common fault is the elbows sliding forward off the plate at the top; pause and check the contact on every rep.

Common Questions

What does an arm blaster do for biceps curls?

It locks the upper arms against the torso so the elbows cannot drift back or forward, removing the shoulder from the curl. The result is a stricter rep with more tension on the biceps, similar to a preacher curl but standing.

How much weight should I curl with an arm blaster?

Expect to use 15 to 25 percent less than your usual dumbbell curl, so 6 to 10 kg per hand is typical for beginners and 12 to 18 kg for experienced lifters. Lighter weight with a full range beats heavier weight with swinging.

Is the arm blaster curl better than a preacher curl?

Both remove momentum; the preacher curl puts more stress on the lower biceps at the stretch, while the arm blaster allows a full standing range and is easier on the elbows. Use whichever lets you feel the biceps most.

Related biceps exercises

Other ways to train the same muscle, with whatever equipment you have.

Dumbbell Concentration Curl
Dumbbell
Dumbbell Drag Bicep Curl
Dumbbell
Dumbbell Hammer Curl
Dumbbell
Kettlebell Biceps Curl
Kettlebell
Barbell Reverse Curl
Barbell
Cable Pulldown Bicep Curl
Cable

See every biceps exercise →

Programming the Dumbbell Biceps Curl (with Arm Blaster)

Track This Exercise in the App

Log your dumbbell biceps curl (with arm blaster) sets in 1RM.fit and watch your estimated 1RM update automatically as you get stronger.

Download on theApp StoreGET IT ONGoogle Play