Shoulder Flexion Back To Wall is a beginner bodyweight exercise for the shoulders (deltoids), with the trapezius and rotator cuff assisting. Most lifters train it for 2 to 3 sets of 8 to 12 reps.
Shoulder Flexion Back To Wall is a shoulder exercise. This exercise builds shoulder stability and strength using bodyweight. Good for lifters looking to bring up shoulder strength without straining the rotator cuff.
Program 2 to 3 sets of 8 to 12 reps in your warm-up before overhead pressing, pull-ups or snatches, or on rest days as a daily mobility drill. It is a movement quality exercise, not a strength builder, so stop each rep at the point where form breaks instead of pushing for range.
Set up with the heels a hand length from the wall so you can keep the back flat, and use bodyweight only; progress by moving the heels closer to the wall, adding a two second pause at the top or holding a 1 to 2 kg plate in each hand. The most common fault is the lower back arching off the wall; fix it by exhaling fully at the start of each rep to pull the ribs down, then raising only as far as that position holds.
It improves overhead shoulder range of motion and teaches you to raise the arms without arching the lower back. That carries over directly to overhead pressing and pull-ups.
Tight lats, a stiff thoracic spine or weak lower traps usually stop the arms short. Regular reps with the ribs held down improve it over a few weeks.
Daily is fine because it is light and low fatigue. Most people see a visible change in range within 2 to 4 weeks of consistent sets.
No, a wall slide keeps the forearms on the wall and slides them up, while this drill raises straight arms freely. The wall version here is harder on lat flexibility.
Other ways to train the same muscle, with whatever equipment you have.
Log your shoulder flexion back to wall sets in 1RM.fit and watch your estimated 1RM update automatically as you get stronger.