1RM.fit1RM.fit
Get Started Free
Exercise Library

Decline Leg Hip Raise

Decline Leg Hip Raise is an intermediate bodyweight exercise for the primary: lower rectus abdominis secondary: hip flexors. Most lifters train it for 3 to 4 sets of 8 to 12 reps.

Lying on a decline bench with your head lower than your hips, you raise your legs toward the ceiling against extra gravitational pull compared to a flat-bench version. The decline angle increases the range of motion and difficulty for the lower abs.

AbsBodyweight
Decline Leg Hip Raise
Primary muscle
Primary: Lower rectus abdominis Secondary: Hip flexors
Equipment
Bodyweight
Difficulty
Intermediate
Typical volume
3–4 sets × 8–12 reps
Category
Abs

How to Do the Decline Leg Hip Raise

  1. Lie on a decline bench with the head at the low end and grip the top edge or pad behind your head.
  2. Press the lower back into the bench and extend the legs straight with a slight knee bend.
  3. Raise the legs together until they point straight up over the hips.
  4. Exhale and curl the hips off the bench, lifting the feet toward the ceiling.
  5. Lower the hips, then the legs, over three seconds until they are in line with the body.
  6. Stop before the lower back arches and begin the next rep from the hover.

Common Mistakes

  • Lower back arching: Lowering past the point of control pulls the spine into extension. End the descent as soon as the back starts to leave the bench.
  • Pulling with the arms: Yanking on the bench to lift the hips cheats the abs. Hold the bench lightly for position and lift with the trunk.
  • Skipping the hip curl: Raising only the legs trains mostly hip flexors. Finish each rep by rolling the pelvis up off the bench.

Programming Tips

Use 3 to 4 sets of 8 to 12 reps in a core block at the end of a session, two to three times per week. It is a progression exercise for the lower abs that bridges floor leg raises and hanging raises, and the decline angle makes the lowering phase the hardest part, so slow negatives are the point.

Set the bench at a modest 15 to 30 degree decline and grip behind the head with elbows relaxed. It is bodyweight; progress by steepening the angle, then by adding 1 to 2 kg ankle weights or a light ball between the feet. The most common fault is the lower back arching as the legs drop; fix it by shortening the range and only lowering as far as the pelvis stays tucked.

Common Questions

What does the decline leg hip raise work?

It works the lower rectus abdominis during the hip curl and the hip flexors during the leg lift. The decline angle increases the load on both compared to a flat bench or the floor.

How steep should the decline bench be for leg raises?

Start at 15 to 20 degrees and move toward 30 degrees as you get stronger. Steeper angles make the lowering phase much harder, so progress slowly.

Are decline leg raises bad for your lower back?

They stress the lower back only if it arches off the bench. Keep the pelvis tucked, shorten the range if needed, and avoid them during acute back pain.

Decline leg raise vs hanging leg raise?

The decline version supports the trunk and removes the grip demand, so it is easier to control. Hanging leg raises allow a bigger hip curl and train the lats and grip, so move to them after mastering the decline.

Related abs exercises

Other ways to train the same muscle, with whatever equipment you have.

Wind Sprints
Bodyweight
Bicycle Crunch
Bodyweight
Decline Crunch
Bodyweight
Suspender Front Plank
TRX
Cable Kneeling Crunch
Cable
Stability Ball Crunch (Full Range Hands Behind Head)
Stability Ball

See every abs exercise →

Programming the Decline Leg Hip Raise

Track This Exercise in the App

Log your decline leg hip raise sets in 1RM.fit and watch your estimated 1RM update automatically as you get stronger.

Download on theApp StoreGET IT ONGoogle Play