1RM.fit1RM.fit
Get Started Free
Exercise Library

Cable Reverse One Arm Curl

Cable Reverse One Arm Curl is a beginner cable exercise for the biceps brachii, with the brachialis and forearms assisting. Most lifters train it for 3 to 4 sets of 10 to 15 reps.

The Cable Reverse One Arm Curl sets up as a curl variation using a cable. A single-joint move for the biceps, curling a cable without momentum from the hips or back. Good for lifters who want to isolate the muscle after bigger pulling or pressing work.

BicepsCable
Cable Reverse One Arm Curl
Primary muscle
Biceps brachii
Secondary muscles
brachialis, forearms
Equipment
Cable
Difficulty
Beginner
Typical volume
3–4 sets × 10–15 reps
Category
Biceps

How to Do the Cable Reverse One Arm Curl

  1. Attach a single D handle to a low pulley and stand facing the machine about half a metre away.
  2. Grab the handle with one hand using an overhand grip so the palm faces the floor.
  3. Stand tall with feet shoulder-width, the working elbow pinned to the side and the wrist straight.
  4. Curl the handle up toward the shoulder by bending the elbow, keeping the palm facing down the whole way.
  5. Pause for one second at the top with the forearm just past parallel to the floor.
  6. Lower the handle over two to three seconds until the arm is fully straight.
  7. Complete all reps on one arm, then switch sides.

Common Mistakes

  • Wrist bending backward: Letting the wrist extend under load strains the forearm tendons. Keep the wrist straight or slightly flexed from start to finish.
  • Elbow drifting forward: Moving the upper arm forward brings the front delt in and shortens the range. Pin the elbow to the ribs for the entire set.
  • Leaning away from the stack: Rocking the torso adds momentum. Keep the feet planted and the body still so only the elbow moves.
  • Going too heavy: Reverse grip curls use less weight than normal curls. Pick a load that allows strict reps without the wrist flexing or the body swinging.

Programming Tips

Program the cable reverse one arm curl for 3 to 4 sets of 10 to 15 reps near the end of an arm or pull session after standard curls. It builds the brachioradialis and brachialis for thicker forearms and upper arms, and it strengthens the elbow for heavier pulling.

Set the pulley at its lowest notch and stand close enough that the cable pulls down at a slight angle. Start with 5 to 10 kg per arm and add 2.5 kg once 15 strict reps are easy; expect to use roughly 60 to 70 percent of your normal one arm curl load. The most common fault is the wrist bending backward under the load; keep a firm grip with the knuckles pointing up and lower the weight until the wrist stays locked.

Common Questions

What muscles does the cable reverse one arm curl work?

It works the brachioradialis and brachialis most, with the biceps brachii assisting. The forearm extensors work hard to keep the wrist straight.

Why is the reverse grip curl so much harder than a regular curl?

The overhand grip puts the biceps in a weaker position, so the smaller brachioradialis and brachialis do more of the work. Use lighter loads and strict form rather than trying to match your normal curl weight.

Are reverse curls good for elbow pain?

They can help with lateral elbow pain by strengthening the forearm extensors, but only when performed light and pain-free. Stop if sharp pain occurs and reduce the load or range.

Cable reverse curl versus dumbbell reverse curl, which is better?

The cable keeps tension at the bottom and top of the rep where a dumbbell loses load, so it is better for isolation. Dumbbells are more convenient and work just as well for building forearm strength.

Related biceps exercises

Other ways to train the same muscle, with whatever equipment you have.

Cable Kneeling Preacher Curl
Cable
Cable Overhead Curl
Cable
Cable Preacher Curl
Cable
Barbell Curl
Barbell
EZ Bar Biceps Curl (With Arm Blaster)
EZ Bar
Machine Preacher Curl
Leverage Machine

See every biceps exercise →

Programming the Cable Reverse One Arm Curl

Track This Exercise in the App

Log your cable reverse one arm curl sets in 1RM.fit and watch your estimated 1RM update automatically as you get stronger.

Download on theApp StoreGET IT ONGoogle Play