Wall Sit From Deficit is an intermediate bodyweight exercise for the primary: quadriceps secondary: glutes.
Standing your feet on a raised platform before sliding into a wall sit lets your knees bend past 90 degrees, increasing the range and difficulty compared to a standard wall sit. The deficit position puts extra time-under-tension on the quads.
Hold 3 to 4 sets of 30 to 60 seconds as a finisher after squats or as a stand-alone quad session when equipment is limited. It belongs at the end of a session because it fatigues the quads without heavy spinal load, and it also works well on rehab days where pain-free isometrics are the goal.
Set the platform far enough from the wall that the shins stay close to vertical in the bottom position, and sink until the hips are just below the knees. Start with bodyweight for 30 seconds; progress by adding 10 seconds per week, then hold a 10 to 20 kg plate on the lap once you reach 60 seconds. The most common fault is drifting up as the burn sets in; fix it by placing a bench or box at the target height and keeping the hamstrings a few centimetres above it.
It works the quadriceps hardest, with the glutes and adductors stabilising. The deeper knee angle shifts more tension to the vastus medialis above the inner knee.
Aim for 30 to 60 seconds per set, 3 to 4 sets. If you can hold more than 90 seconds, add weight on your lap rather than holding longer.
For healthy knees it is safe and often used in rehab because the joint load is static and controlled. If you have patellar pain, stay at 90 degrees and build time there before going deeper.
The deficit version lets the knees bend past 90 degrees, which lengthens the quads under load and makes the hold harder. The regular wall sit is the better starting point if you cannot yet hold 60 seconds.
Other ways to train the same muscle, with whatever equipment you have.
Log your wall sit from deficit sets in 1RM.fit and watch your estimated 1RM update automatically as you get stronger.