1RM.fit1RM.fit
Get Started Free
Exercise Library

Cable Rear Drive

Cable Rear Drive is an intermediate cable exercise for the primary: glutes secondary: hamstrings. Most lifters train it for 3 to 4 sets of 8 to 12 reps.

Anchoring a cable at the hip and driving your leg backward and down against resistance mimics the rear leg drive phase of sprinting. It's commonly used by sprinters and jumpers to build hip extension power specific to their sport.

GlutesCable
Cable Rear Drive
Primary muscle
Primary: Glutes Secondary: Hamstrings
Equipment
Cable
Difficulty
Intermediate
Typical volume
3–4 sets × 8–12 reps
Category
Glutes

How to Do the Cable Rear Drive

  1. Attach an ankle strap to the low pulley, strap it to one ankle and face the stack holding the frame.
  2. Step back until the cable is taut with the working leg flexed forward at the hip, knee slightly bent.
  3. Stand tall on the support leg with a soft knee and brace the core.
  4. Drive the working leg back and down in a powerful arc until the hip is fully extended.
  5. Squeeze the glute at the end without arching the lower back.
  6. Return the leg forward under control over two seconds, then repeat and switch legs.

Common Mistakes

  • Arching the lower back: Pushing past hip extension makes the spine extend to finish. Keep the ribs down and stop when the glute is squeezed.
  • Swinging the leg: Rocking the whole body to throw the leg back removes glute work. Hold the frame and keep the torso still.
  • Bending the knee too much: Turning the movement into a hamstring curl shortens the lever. Keep the knee only slightly bent throughout.
  • Standing too close to the stack: If the cable is slack at the start, the stretched position is wasted. Step back until the cable is taut with the leg forward.

Programming Tips

Program the cable rear drive after your main hip hinge or as an accessory on a lower body or athletic day. Run 3 to 4 sets of 8 to 12 reps per leg with 60 seconds rest. It builds glute and hamstring power through the full hip extension range and is especially useful for sprinters and jumpers who need a strong rear leg drive.

Ankle strap snug, cable taut with the leg forward, torso tall and hands on the frame. Start with 10 to 15 kg on the stack and add one plate when 12 reps are powerful and the back stays still. The most common fault is arching the lower back to finish the rep; stop when the glute squeezes and keep the ribs tucked.

Common Questions

What does the cable rear drive work?

It works the glutes and hamstrings through hip extension, with the lower back and core stabilizing. The support leg also trains balance and glute medius.

Is the cable rear drive the same as a cable kickback?

They are close relatives. A kickback usually uses a shorter range and more knee bend, while the rear drive starts with the leg forward and drives through a longer, sprint like arc.

How much weight should I use for cable rear drives?

Start with 10 to 15 kg on the stack per leg for sets of 8 to 12. Power matters more than load, so keep the weight moderate and move it fast.

Does the cable rear drive help sprinting?

It trains hip extension in a range similar to the push off phase of a sprint, which is why it is popular with sprinters. It supports but does not replace sprint practice itself.

Related glutes exercises

Other ways to train the same muscle, with whatever equipment you have.

Cable Kneeling Pull Through
Cable
Cable Pull Through
Cable
Reverse Hyperextension On Stability Ball
Ball
Landmine Rear Lunge
Barbell
Dumbbell Hip Thrust
Dumbbell
Bridge Hip Abduction
Bodyweight

See every glutes exercise →

Programming the Cable Rear Drive

Track This Exercise in the App

Log your cable rear drive sets in 1RM.fit and watch your estimated 1RM update automatically as you get stronger.

Download on theApp StoreGET IT ONGoogle Play